Rotary Fixture FAQ
Question
- Answer
What kinds of operational checks can I do to ensure that my Rotary Fixture is working right?
- Make sure that when you install the rotary in the table socket that the cone briefly rotates.
- Verify that when you click “Rotary” in the focus tab of the VCP that the red diode is close to the centerline of the Rotary.
- Be sure to have “Rotary Fixture” selected in the Fixture Type selection menu.
What kind of adjustments can I make help optimize my Rotary fixture?
- Always check the focus of each object being engraved with the rotary.
- Measure the diameter accurately and enter the value in the driver.
What if my system will not detect the Rotary Fixture?
- Be sure the rotary has been set into the table socket connector completely.
- Be sure that “Rotary Fixture” is selected in the Fixture Type selection menu.
What is the best way to clean and maintain my Rotary Fixture?
- Use light industrial cleaner to keep the cone clean and the base free of debris.
Site Admin
There is also some info here on using CorelDraw with the rotary engraving fixture:
viewtopic.php?f=5&t=3078
viewtopic.php?f=5&t=3078