Hi All,
I have a 1993 Triac ATC with a Fanuc OM-C Controller and i would like to enable drip feeding.
i can send programs either way from an RS232 cable, but i seem to have a very limited memory, my controller is telling me i only have 4095 i assume bites, apparently the machine had a memory upgrade but i had to re enter the parameters after loosing them so the extra memory may not be enabled.
I have looked in the ladder and i do have G127.5 but i dont have a tape switch, i can find lots of info about changing Diagnostics and parameters to enable drip feeding, there seems to be lots of different ways to do it i am just not sure what way to go.
any help would be much appreciated.
cheers,
Tom
Triac Fanuc OM-C Drip Feed
CNC related queries on software; firmware; DOS; Windows; parameters; programming; error messages etc.
Moderators: Martin, Steve, Mr Magoo
-
- Posts: 2
- Joined: Mon 18 Feb , 2019 10:08 am
- Hardware/Software: 1993 trial atc
Jump to
- Welcome
- ↳ Please read these first...
- ↳ Announcements
- CNC / Machines
- ↳ Machines
- ↳ Compact 1000
- ↳ Cyclone
- ↳ EasiMill / EasiTurn
- ↳ Meteor
- ↳ Micromill / Microturn
- ↳ MicroRouter
- ↳ MicroRouter Compact
- ↳ MicroRouter Vertical / MaxiRouter
- ↳ Mirac
- ↳ Novamill
- ↳ NovaTurn
- ↳ Orac
- ↳ PCB Engraver
- ↳ Quatro
- ↳ Router 2600
- ↳ Senior (Tom)
- ↳ StarMill
- ↳ StarTurn
- ↳ Triac
- ↳ Triton
- ↳ Turn270
- ↳ VersaLaser
- ↳ Viceroy
- ↳ VMC 1300
- ↳ ZeroCentre/ZeroTurn/ZeroBore
- ↳ Electronics
- ↳ Software
- ↳ Downloads
- CAD / CAM Software
- ↳ QuickCAM / LaserCAM 2D Design
- ↳ QuickCAM 3D/PRO/4D
- ↳ QuickTURN 2D Design
- ↳ TechSoft 2D Design
- ↳ Post Processors
- ↳ Solidworks
- ↳ VR Milling - All Versions
- ↳ VR Turning - All Versions
- ↳ Other CAD CAM and CNC
- 3D Printing / Rapid Prototyping
- ↳ UP! 3D Printer
- General
- ↳ Project Of The Week
- ↳ Denford Classifieds
- ↳ F1 / 4x4 / GT Racing In Schools
- ↳ Suggestions and Feedback
- ↳ User Stories / Projects / Courseware
- CIM
- ↳ Robots / CIM / VR CIM
- Random Picture Galleries
- ↳ Vintage Pictures