more or less stepover?
Moderators: Martin, Steve, Mr Magoo
more or less stepover?
Here is a photo of something that I had bobcad make a code for. It has lines cut into it that aren't supposed to be there. I'm using a flat end mill. Should I use more or less stepover distance. The bit is 3/16.
- Attachments
-
- vkry.JPG (150.4 KiB) Viewed 3439 times
-
Denford Admin
- Site Admin
- Posts: 3634
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: more or less stepover?
It's hard to see from the photo - I take it the shape is curved ?
That type of design would probably come out better with a ballnose cutter - a flat cutter will leave lines on curved surfaces as there is only a small part of the tool diameter in contact when machining a slope.
Increasing stepover would improve it but I'd try using a ballnose for the finishing (use a larger flat bottom cutter for roughing if required)
That type of design would probably come out better with a ballnose cutter - a flat cutter will leave lines on curved surfaces as there is only a small part of the tool diameter in contact when machining a slope.
Increasing stepover would improve it but I'd try using a ballnose for the finishing (use a larger flat bottom cutter for roughing if required)