ClassFactory cannot supply requested class error
Posted: Wed 12 Dec , 2012 14:40 pm
Customer has recently had this error:
ClassFactory cannot supply requested class error If the software has not installed properly then you normally get a Class not registered error.
Previous ClassFactory errors have been fixed with a replacement Baldor top card, however, in this instance the same machine could be run from a different PC so the problem was narrowed down to something on the PC.
It was fixed by installing easyUpgrader from the VR Milling 5 CD, checking that the firmware etc. was up to date (which it was)
Then, UNinstalling and REinstalling VR Milling v5 made the error go away.
ClassFactory cannot supply requested class error If the software has not installed properly then you normally get a Class not registered error.
Previous ClassFactory errors have been fixed with a replacement Baldor top card, however, in this instance the same machine could be run from a different PC so the problem was narrowed down to something on the PC.
It was fixed by installing easyUpgrader from the VR Milling 5 CD, checking that the firmware etc. was up to date (which it was)
Then, UNinstalling and REinstalling VR Milling v5 made the error go away.