Possible to use lathcam for my starturn4 upgrade at all?

CNC related queries on software; firmware; DOS; Windows; parameters; programming; error messages etc.

Moderators: Martin, Steve, Mr Magoo

Post Reply
willsauto
Posts: 11
Joined: Fri 30 Jun , 2006 4:21 am
Location: London , UK. + HK depot
Contact:

Possible to use lathcam for my starturn4 upgrade at all?

Post by willsauto » Fri 30 Jun , 2006 5:28 am

Hello there:

anyone can help me to run my starturn4 at the lowest cost?

can i use lathcam fo my machine?


Kind regards

Will
Willsauto

User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Post by Denford Admin » Fri 30 Jun , 2006 8:42 am

If you upgraded to VR Turning (see other reply) you would be able to use any Fanuc style CAM system to produce CNC code for this machine.

Post Reply