Quickcam turning?

CNC related queries on software; firmware; DOS; Windows; parameters; programming; error messages etc.

Moderators: Martin, Steve, Mr Magoo

Post Reply
paul
Posts: 18
Joined: Tue 17 Oct , 2006 11:55 am
Location: Newcastle

Quickcam turning?

Post by paul » Wed 18 Apr , 2007 13:10 pm

I have just noticed quickcam turning installed onto one of the school computers connected to my milling machine, Its fully working and registered but I dont seem to have the disk and cant find it in the download section, is this a obsolete program now, it looks like a better option to lathe cam designer.
Cheers
Paul

User avatar
Denford Admin
Site Admin
Posts: 3642
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Post by Denford Admin » Wed 18 Apr , 2007 14:26 pm

QuickCAM Turning was shelved due to other commitments, and the even better version coming along shortly.

If it works for you then great, but I'm afraid it will not be supported in the future.

I'll see if I can find the last known working version, and upload it

User avatar
Denford Admin
Site Admin
Posts: 3642
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Post by Denford Admin » Wed 18 Apr , 2007 14:44 pm


paul
Posts: 18
Joined: Tue 17 Oct , 2006 11:55 am
Location: Newcastle

Post by paul » Wed 18 Apr , 2007 18:24 pm

Thanks, it will be interesting to see the new development as lathecam designer is a little limited.
Cheers
Paul

Post Reply