VR Milling v2.32 not working with seckey.tff

CNC related queries on software; firmware; DOS; Windows; parameters; programming; error messages etc.

Moderators: Martin, Steve, Mr Magoo

Post Reply
robcnc124
Posts: 2
Joined: Wed 23 Mar , 2022 10:10 am

VR Milling v2.32 not working with seckey.tff

Post by robcnc124 » Wed 23 Mar , 2022 15:54 pm

Hi All

I have been tasked with getting the school Mirco CNC router working again.

I have all the old software and floppy disk security keys, I have checked the license with the denford software, it showed me I have VR CNC MILLING license.

I have downloaded VR milling v2 bought an external floppy disk drive installed the software while pointing it at the seckey.tff file but VR milling is coming up with the dongle/floppy disk not installed. I have tried transferring the key to a USB and that didn't work either

I have also tried the flash.in file transfer next but still not working. Is there anything else I can try?

I also have QuickCAM 2D Design and the seckey.tff worked fine when installed

Martin
CNC Guru
CNC Guru
Posts: 1897
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: VR Milling v2.32 not working with seckey.tff

Post by Martin » Mon 28 Mar , 2022 8:56 am

I think the Seckey.tff license is for VR Milling version 5.

You can download it from the Denford website.

robcnc124
Posts: 2
Joined: Wed 23 Mar , 2022 10:10 am

Re: VR Milling v2.32 not working with seckey.tff

Post by robcnc124 » Tue 29 Mar , 2022 12:22 pm

Thnaks for the feedback. i have downloaded V5 and it wont install on windows 10 pro, tried it a few times but no luck

Post Reply