Mitsubishi RV-M1 Accuracy

Help and info about Denfords CIM* and Virtual Reality CIM systems Robots and ASRS**
*(Computer Integrated Manufacturing) **(Automated Storage and Retrieval System)

Moderators: Martin, bradders, Steve, Mr Magoo

Post Reply
Posts: 4
Joined: Mon 07 Mar , 2011 13:18 pm
Hardware/Software: RV-M1 Mitsubishi Movemaster

Denford Virtual Reality

Mitsubishi RV-M1 Accuracy

Post by pjk1987 » Wed 30 Mar , 2011 12:03 pm

I hope to measure our RV-M1 robot's accuracy utilising a CMM and calibrate it accordingly using ISO 9283 definitions.

Would anyone know the best method of doing this?



User avatar
Denford Admin
Site Admin
Posts: 3600
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse

Re: Mitsubishi RV-M1 Accuracy

Post by Denford Admin » Wed 30 Mar , 2011 14:16 pm

Nobody here has ever done anything like it.
I imagine its a long, labourious procedure as every combination of every joint position will have different rigidity.
eg, With all joints pointing upwards, turning just the wrist will show pretty good accuracy / repeatability as the load is direct through all the joints
With the wrist pointing out sideways it'll be a completely different matter as the load forces act on the the motor/belts/chains as well.
Good luck :dumbfounded:

Post Reply