parameters

What little info there is on the QuatroMill

Moderators: Martin, Steve, Mr Magoo

Post Reply
streethawk
Posts: 3
Joined: Tue 08 Nov , 2016 9:20 am
Hardware/Software: Quatro mill
Triac mill
Cyclone lathe

parameters

Post by streethawk » Tue 22 Nov , 2016 9:14 am

I appreciate the parameters and electrical drawings in previous post. I've input the parameters but when I start up it immediatley shows gross position error D, I've tried changing the values in MP57 and MP169 but all that seems to achieve is the Y axis lurging and a gross position error A occuring.

Any help or advise?

Post Reply