ref quatro running heidenhain 355

What little info there is on the QuatroMill

Moderators: Martin, Steve, Mr Magoo

Post Reply
bikermickyc
Posts: 16
Joined: Wed 11 Jul , 2012 19:01 pm
Hardware/Software: Denford Quatromill any help in setting up etc appreciated as we have just got one from auction- has a heidenhain controller- and seems good nick no backlash in screws etc- have any members any experience of this well built machine- thanks mike

ref quatro running heidenhain 355

Post by bikermickyc » Mon 14 Apr , 2014 13:22 pm

Hi I go to reference the axis and comes up with z axis drive fault motor seems free but any ideas- Mike

Martin
CNC Guru
CNC Guru
Posts: 1897
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: ref quatro running heidenhain 355

Post by Martin » Mon 14 Apr , 2014 15:53 pm

Check the 3 axis drives in the electrical box. You should have 3 Norwin drives in a rack. Check that all 3 have a green LED lit.

bikermickyc
Posts: 16
Joined: Wed 11 Jul , 2012 19:01 pm
Hardware/Software: Denford Quatromill any help in setting up etc appreciated as we have just got one from auction- has a heidenhain controller- and seems good nick no backlash in screws etc- have any members any experience of this well built machine- thanks mike

Re: ref quatro running heidenhain 355

Post by bikermickyc » Mon 14 Apr , 2014 18:25 pm

the 2on the left are green the one on the end is red?

Martin
CNC Guru
CNC Guru
Posts: 1897
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: ref quatro running heidenhain 355

Post by Martin » Mon 14 Apr , 2014 22:55 pm

Can you swap them over?

Post Reply