Triac Fanuc - ATC 1989
Posted: Tue 18 Jan , 2022 18:48 pm
Hi
have a issue, after some troubleshooting , i have found out that most of my misery with the Mill, goes back to a Controller Card with intermitting faults. where some key functions not working.
i was thinking of changing this card.
but i'm at loss for which one to get. since its a fairly old machine the parts a expensive. so i was hoping for something in the line of retrofit of the card that works with rest of the machine, if not all, then most parts.
is there anyone that have done this before??
leaving some info of the mill
have a issue, after some troubleshooting , i have found out that most of my misery with the Mill, goes back to a Controller Card with intermitting faults. where some key functions not working.
i was thinking of changing this card.
but i'm at loss for which one to get. since its a fairly old machine the parts a expensive. so i was hoping for something in the line of retrofit of the card that works with rest of the machine, if not all, then most parts.
is there anyone that have done this before??
leaving some info of the mill