Relay for the Emergency stop button ?

Information and questions about Denford CNC Control electronics, general electrical issues, cables, diagrams, stepper motors, drives etc...

Moderators: Martin, Steve, Mr Magoo

Post Reply
MikeR
Posts: 12
Joined: Wed 17 Nov , 2021 20:03 pm
Hardware/Software: Denford microrouter 2000? Windows 98

Relay for the Emergency stop button ?

Post by MikeR » Sun 21 Nov , 2021 19:22 pm

Hello is this the relay for the Emergency stop button ? It likes to buzz when the e stop is off and I get the “ stop” code .
Attachments
3C789DFD-8ADE-433E-A5FD-274AFD5C1105.jpeg
3C789DFD-8ADE-433E-A5FD-274AFD5C1105.jpeg (474.76 KiB) Viewed 5400 times

Martin
CNC Guru
CNC Guru
Posts: 1897
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: Relay for the Emergency stop button ?

Post by Martin » Mon 22 Nov , 2021 13:14 pm

This is the nearest drawing I was able to locate.

You should be able to trace the wires back.
Attachments
1995 MicroMill (MicroTurn) Wiring Diagram.pdf
(1.16 MiB) Downloaded 245 times

MikeR
Posts: 12
Joined: Wed 17 Nov , 2021 20:03 pm
Hardware/Software: Denford microrouter 2000? Windows 98

Re: Relay for the Emergency stop button ?

Post by MikeR » Tue 23 Nov , 2021 3:51 am

Thanks Martin ( again ) ohm the relay wires back to the emergency stop button . It’s connected to the relay : both wires are showing it’s connected . This Relay likes to buzz all the time . I know that could mean low power or low voltage . I’m gonna put a new relay in and see what happens . At least if it’s good . I’ve eliminated one idea. Hopefully that’s it .

Post Reply