Work light voltage

Information and questions about Denford CNC Control electronics, general electrical issues, cables, diagrams, stepper motors, drives etc...

Moderators: Martin, bradders, Steve, Mr Magoo

Post Reply
OCD_Machinist
Posts: 2
Joined: Sat 01 May , 2021 12:28 pm
Hardware/Software: Denford Micro mill 2000 l, Centroid Acorn

Work light voltage

Post by OCD_Machinist » Sun 02 May , 2021 7:42 am

Hello, I have a Denford Micromill 2000. from the diagrams it looks like the work light is 24 Volts DC. Am I correct? and does anyone know the amps? thanks !

Martin
CNC Guru
CNC Guru
Posts: 1804
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: Work light voltage

Post by Martin » Sun 02 May , 2021 12:22 pm

We have fitted various lights over the years so not sure on the amps but yes they will all have been 24 volts DC.

OCD_Machinist
Posts: 2
Joined: Sat 01 May , 2021 12:28 pm
Hardware/Software: Denford Micro mill 2000 l, Centroid Acorn

Re: Work light voltage

Post by OCD_Machinist » Mon 03 May , 2021 1:11 am

hello, thank you for the help. would you know a range of amps I have a 12volt 2a wall adapter I wanted to plug into to see if it works my main boards don't.

Post Reply