DENFORD EASIMILL HELP

Information and questions about Denford CNC Control electronics, general electrical issues, cables, diagrams, stepper motors, drives etc...

Moderators: Martin, Steve, Mr Magoo

Post Reply
Wobbler
Posts: 2
Joined: Tue 12 Jan , 2021 20:58 pm
Hardware/Software: Denford Easimill

Solidworks, Mach3

DENFORD EASIMILL HELP

Post by Wobbler » Wed 28 Apr , 2021 19:11 pm

Hi All

I have been struggling to rewire my easimill control panel.
I am now at the stage of setting up Mach3 with the BoB and drivers and UC100 motion controller using original stepper motors.
Everything seems to power up okay and relevant Led's are lit and I can hear the motors hold.
But for the life of me, I cannot make any of the motors move.

Can anyone help with known settings for the driver and mach3 or advise what I should check.
Thank you. :delirious:

Post Reply