Denford Desk-Top Tutor membrane
Posted: Fri 12 Mar , 2021 13:58 pm
I was wondering if anyone has any suggestions as to where to get / how to make membranes for the (later?) Desk-Top Tutor
Any suggestions as to who / which company may have made them in the first place?
Thanks for any time / guidance / suggestions.
Did think about just using an thick heat laminated sheet as a raf way of putting an expanded custom keyboard.
{I've not got into wiring it up yet, but the plan is to use it with my lathe Denford Orac, mill, router and plasma cutter via linuxcnc..... thats the pipe dream.... }
understand its a DB25 connector wired as RS-232
Any suggestions as to who / which company may have made them in the first place?
Thanks for any time / guidance / suggestions.
Did think about just using an thick heat laminated sheet as a raf way of putting an expanded custom keyboard.
{I've not got into wiring it up yet, but the plan is to use it with my lathe Denford Orac, mill, router and plasma cutter via linuxcnc..... thats the pipe dream.... }
understand its a DB25 connector wired as RS-232