DOS and VR EPROM Versions

Information and questions about Denford CNC Control electronics, general electrical issues, cables, diagrams, stepper motors, drives etc...

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
Steve
CNC Guru
CNC Guru
Posts: 1432
Joined: Tue 21 Feb , 2006 16:15 pm
Location: Denford UK

DOS and VR EPROM Versions

Post by Steve » Fri 27 Nov , 2020 10:26 am

Here is a list of the EPROM numbers fitted to the Smartstep, Denstep and Nextstep controller cards.

All the machines were supplied with DOS software before 2000 and a change over to the current VR Turning and VR Milling software in late 2000.

To identify what software will run on your controller you can simply check the version of the EPROM fitted to the control card.

If you have a DOS EPROM then you cannot use the latest VR Software without replacing the EPROM


DOS AND VR EPROM VERSION NUMBERS.pdf
(7.12 KiB) Downloaded 478 times

User avatar
Steve
CNC Guru
CNC Guru
Posts: 1432
Joined: Tue 21 Feb , 2006 16:15 pm
Location: Denford UK

Re: DOS and VR EPROM Versions

Post by Steve » Tue 16 Mar , 2021 9:29 am

EPROM LOCATION NEXT STEP CARD
EPROM.jpg
EPROM.jpg (105.39 KiB) Viewed 9165 times

User avatar
Steve
CNC Guru
CNC Guru
Posts: 1432
Joined: Tue 21 Feb , 2006 16:15 pm
Location: Denford UK

Re: DOS and VR EPROM Versions

Post by Steve » Wed 24 Mar , 2021 9:39 am

EPROM LOCATION SMART STEP CARD
SMARTSTEP EPROM.jpg
SMARTSTEP EPROM.jpg (218.83 KiB) Viewed 9123 times

Post Reply