Wireing spindle motor to work with Mach 3

Information and questions about Denford CNC Control electronics, general electrical issues, cables, diagrams, stepper motors, drives etc...

Moderators: Martin, Steve, Mr Magoo

Post Reply
Riddersholm
Posts: 1
Joined: Sat 02 Feb , 2013 19:56 pm

Wireing spindle motor to work with Mach 3

Post by Riddersholm » Sat 02 Feb , 2013 20:12 pm

Hello.

It have probaly been asked alot of times.

But i really need some help.

Ok, i bought a Denford Triac from 1992 with a DOS computer as a controller for 50£ but the DOS computer is bust.

So i decied to convert it to MACH 3 as my first conversoin.

But boy i am in over my head :-?

I have got the Axises stepper motors to work by useing a new break out board, with new step drivers, i diden think the spindle would be such a big problem.

I really need someone to tell me how i connect the motor from scratch since i took out everything, i have it laying but now cant remember what goes where :shock:

Pictures of how to wire the DC would really help me out.

Best Regards Riddersholm
Denmark, Jutland
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Re: Wireing spindle motor to work with Mach 3

Post by Denford Admin » Mon 04 Feb , 2013 10:07 am

Is it the original spindle motor and drive ?
Probably best post photos of what you have and someone might be able to tell you what goes where
Top
Post Reply

Return to “Electronics”