zero turn lathe

Any information regarding the Denford ZeroCentre ZeroTurn ZeroBore Fanuc CNC machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
Emimec
CNC Expert
CNC Expert
Posts: 125
Joined: Tue 03 Feb , 2009 10:42 am
Location: North London

zero turn lathe

Post by Emimec » Tue 23 Jun , 2015 7:54 am

I have been offered a zero turn lathe, but ask if this is more powerful than the cyclone I owned. Looks to me that both have a 5 hp main motor ?
Also, it's says it's a slant bed, but compared to my cyclone, it doesn't look the same layout. Bob

angel-tech
CNC Guru
CNC Guru
Posts: 525
Joined: Tue 14 Nov , 2006 12:12 pm
Hardware/Software: .....
4 Quatros
3 Oracs
2 Easiturn atc
12 station lathe atc
Mach 3
Location: Quatroland

Re: zero turn lathe

Post by angel-tech » Tue 23 Jun , 2015 14:56 pm

it looks more substantial than the cyclone

Emimec
CNC Expert
CNC Expert
Posts: 125
Joined: Tue 03 Feb , 2009 10:42 am
Location: North London

Re: zero turn lathe

Post by Emimec » Tue 23 Jun , 2015 15:15 pm

That was helpful ! I worked that one out already

angel-tech
CNC Guru
CNC Guru
Posts: 525
Joined: Tue 14 Nov , 2006 12:12 pm
Hardware/Software: .....
4 Quatros
3 Oracs
2 Easiturn atc
12 station lathe atc
Mach 3
Location: Quatroland

Re: zero turn lathe

Post by angel-tech » Tue 23 Jun , 2015 15:25 pm

the cyclone usually has a 3hp spindle motor, and as stated before is less substantial than the zeroturn. :lol:

Emimec
CNC Expert
CNC Expert
Posts: 125
Joined: Tue 03 Feb , 2009 10:42 am
Location: North London

Re: zero turn lathe

Post by Emimec » Tue 23 Jun , 2015 19:40 pm

Photo won't load, I'll try again

Emimec
CNC Expert
CNC Expert
Posts: 125
Joined: Tue 03 Feb , 2009 10:42 am
Location: North London

Re: zero turn lathe

Post by Emimec » Wed 24 Jun , 2015 8:28 am

Seems my cyclone spec plate was stamped wrong. Says main motor was 5hp, but beside that it says 2.2kw, which converts to 3hp, which is as rightly pointed out on one reply. Thanks.

Emimec
CNC Expert
CNC Expert
Posts: 125
Joined: Tue 03 Feb , 2009 10:42 am
Location: North London

Re: zero turn lathe

Post by Emimec » Wed 24 Jun , 2015 9:36 am

Photo of my plate
Attachments
2.jpg
2.jpg (263.93 KiB) Viewed 10616 times
2.jpg
2.jpg (263.93 KiB) Viewed 10616 times

Post Reply