Page 1 of 1
Just bought a zero center
Posted: Fri 01 Feb , 2013 13:27 pm
by jonny
Hi All, new to this forum.
I just bought a zero center and need some help.
Can anyone tell me what pull studs to use? my machine did not come with any tooling so i have no reference.
Thanks
John
Re: Just bought a zero center
Posted: Fri 01 Feb , 2013 15:00 pm
by Denford Admin
Sorry but all the info we have is on here and it isn't much. Zerocentre's are even rarer than the Zeroturn of which there is less than 20.
Maybe you can get a rough idea from the ZeroCentre brochure:
viewtopic.php?f=52&t=2969
which shows the tools side on and states it's an ISO 40, 78mm diam. spindle taper.
Re: Just bought a zero center
Posted: Fri 01 Feb , 2013 15:18 pm
by jonny
Thanks for the reply, I have found out a iscar part psbt4045m16 is the one but there are a few different types.
Another thing is how to connect up to a pc to drip feed ? what cable and software i need?
Thanks in advance for any help
John
Re: Just bought a zero center
Posted: Fri 01 Feb , 2013 15:32 pm
by Denford Admin
Re: Just bought a zero center
Posted: Fri 01 Feb , 2013 17:41 pm
by jonny
Thanks for that, a lot to digest.
I managed to talk to the previous owner and he is sending me all the manuals and even the wiring diagram and a few spare pull studs for reference, happy days
I will scan and send denford the info when i get it to put on this website for everyone.
John
Re: Just bought a zero center
Posted: Thu 21 Feb , 2013 10:15 am
by jonny
Hi All,
Machine all up and running and drip feeding, very happy
I have got the manuals with all the parameters as well, I don't have time to scan them but if anyone needs any info just drop me a message and i will be happy to help.
One other thing, I tried to change the spindle belt to the higher speed, but the top of the belt would rub on the underneath of the spindle motor mount plate, any ideas anyone???
Thanks
John