Page 1 of 1
ZeroTurn spindle bore
Posted: Mon 31 Oct , 2011 10:24 am
by Hood
Hi,
I may be getting a ZeroTurn and was wondering if anyone knows the spindle bore?
Hood
Re: ZeroTurn spindle bore
Posted: Wed 02 Nov , 2011 10:13 am
by Denford Admin
Sorry - I've had a look and we haven't seen any Zeroturn brochures when scanning the old documents in.
These machines are pretty rare and there is definately a lack of info about them here
Re: ZeroTurn spindle bore
Posted: Wed 02 Nov , 2011 19:30 pm
by Hood
Thanks
Yes, had a look through the info on the forum and the brochure mentions 65mm spindle but that seems to be the outer. I think I also read they have a A2-5 spindle nose so was thinking 38mm would be about right.
Not sure if I will be getting it anyway as I have not heard back
Hood