centre drill off centre
Posted: Wed 23 Jan , 2019 17:36 pm
hello,
I suspect its simply something Ive forgotten to do...
On a Turn 270M I am trying to drill out a centre hole. The centre approaches the piece off centre by about 10mm. I would imagine I've forgotten to do something with datums, but would appreciate it if someone could go through how to set up the centre drill datum so I can see what Ive missed.
Thanks
Jon
I suspect its simply something Ive forgotten to do...
On a Turn 270M I am trying to drill out a centre hole. The centre approaches the piece off centre by about 10mm. I would imagine I've forgotten to do something with datums, but would appreciate it if someone could go through how to set up the centre drill datum so I can see what Ive missed.
Thanks
Jon