Thread milling and tool wear adjustment
Posted: Fri 30 Jun , 2023 19:02 pm
I have been thread milling on my triac.
I would like to be able to adjust tool wear compensation but the only option in vr milling seems to be tool diameter and length.
If I adjust the program on fusion 360 for wear, the cutting program will only run if the in computer option is ticked on fusion.
If I change the fusion 360 option to wear or in control, when I run it on vr milling I get compensation error and following message.
(Unable to compensate for a groove smaller than the tool radius)
Can anyone help ?
I would like to be able to adjust tool wear compensation but the only option in vr milling seems to be tool diameter and length.
If I adjust the program on fusion 360 for wear, the cutting program will only run if the in computer option is ticked on fusion.
If I change the fusion 360 option to wear or in control, when I run it on vr milling I get compensation error and following message.
(Unable to compensate for a groove smaller than the tool radius)
Can anyone help ?