rubber seal bearings or not
Posted: Thu 24 Jun , 2021 19:18 pm
i mashed my spindle bearings ,they were bep . but i thought i would keep the rubbish out and fitted rs (rubber seal) bearings .
ive noticed the casting and spindle is getting hot ,43c
i have the angular contact bearings not too tight ,just enough to not wobble.
so is the issue with rubber seals and should i just hook them out and run open ?
thanks
ive noticed the casting and spindle is getting hot ,43c
i have the angular contact bearings not too tight ,just enough to not wobble.
so is the issue with rubber seals and should i just hook them out and run open ?
thanks