Denford Software & Machines

Dear Sirs,

We bought the Triac PC in 1999. A DOS software came together
to operate it.

I would like to know if there is an update for such software.
I tried to search in the denford´s site, and I found several
softwares that can be downloaded. However, I am not
sure that these softwares can be used to operate the
Triac PC.

I appreciate any information.

Marcos Tsuzuki

Please refer to the link below.

This will let you identify the control card you have and then the apropriate upgrade.

I think you will have the rack mounted card so the UGR007 will probably apply. You can only upgrade within the version of software you have for free.

Provided the machine has a rack card you can replace the card and then use VR Milling 5 and a USB connection


viewtopic.php?t=116&highlight=reasons+upgrade