Page 1 of 1
BT35 tool holders
Posted: Wed 21 Sep , 2011 20:51 pm
by mickgc29
I have just got a denford triac and found a supply of new Nikken BT35 tool holders in sizers 5/16 , 1/4 , 3/16 and shell holder
is there any body else needing these tool holders so we could share postage cost
cheers Mick
Re: BT35 tool holders
Posted: Wed 21 Sep , 2011 21:06 pm
by jpmiller
My triac is bt30 it has a bt30/70/er 32 collet
In it at the moment I found the same thing from
Tool holders direct if anyone is needing them.
Re: BT35 tool holders
Posted: Wed 21 Sep , 2011 21:37 pm
by mickgc29
my triac as the tool changer and as the BT35 tool holders well i hope so lol as i have just oreder a few of them
cheers Mick
Re: BT35 tool holders
Posted: Thu 22 Sep , 2011 17:17 pm
by angel-tech
Mick if your triac has the 6 station carousel then it will have a BT35 spindle, it's the triac with the eight station carousel that has the BT30 spindle.
Re: BT35 tool holders
Posted: Fri 23 Sep , 2011 9:05 am
by Lone_Ranger
mickgc29 wrote:I have just got a denford triac and found a supply of new Nikken BT35 tool holders in sizers 5/16 , 1/4 , 3/16 and shell holder
is there any body else needing these tool holders so we could share postage cost
cheers Mick
Just my personal opinion but I think you should try to stick to Metric toolholders, much easier to get tooling for them
.