Pratt Bernard 3 jaw Chuck Starturn pdf

All info relating to the Denford StarTurn CNC lathes

Moderators: Martin, bradders, Steve, Mr Magoo

Post Reply
User avatar
Denford Admin
Site Admin
Posts: 3600
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse

Pratt Bernard 3 jaw Chuck Starturn pdf

Post by Denford Admin » Mon 04 Apr , 2011 9:34 am

(839.84 KiB) Downloaded 1420 times

Posts: 26
Joined: Wed 02 Mar , 2011 9:48 am
Hardware/Software: Easiturn 3

Re: Pratt Bernard 3 jaw Chuck Starturn pdf

Post by rickturner646 » Wed 13 Apr , 2011 18:11 pm

Here's the only other document on the Pratt-Burnerd chuck that I've been able to locate - I got this from P-B and it's the only document that they have.

This is the installation, operation, and maintenance manual for their Mk3 self-contained power chuck, which was fitted to later Denford lathes. Earlier ones seem to have the Mk2 chuck but the technical folks at P-B told me that there is not much difference between them.

One final comment - type BK16 jaws (from jaw manufacturers such as Thame Engineering) fit this type of power chuck. I can post the dimensions etc if anybody wants them (let me know). They would not be hard to make on a mill if you cant locate any, or if you want a particular type of jaw end for that oddball job.

Self-Contained Power Chuck Mk3 Installation and Operations Manual.PDF
(909.89 KiB) Downloaded 2051 times

Post Reply