StarMill circa 1989

All info relating to the Denford Starmill CNC milling machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
davisa
Posts: 3
Joined: Mon 05 Feb , 2007 12:17 pm

StarMill circa 1989

Post by davisa » Mon 05 Feb , 2007 17:13 pm

Is it possible to drip feed to this machine. We have just found this Starmill a few days ago and would like to get it moving. A manual would be useful :?: A picture has been added. :!:
Attachments
P1010004.JPG
P1010004.JPG (55.12 KiB) Viewed 4288 times
Last edited by davisa on Tue 06 Feb , 2007 17:49 pm, edited 3 times in total.

User avatar
Denford Admin
Site Admin
Posts: 3642
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Post by Denford Admin » Tue 06 Feb , 2007 9:53 am

I think there are different control version of these - a photo of the electronics would help.

I've found a NEE version and a Baldor / DOS version (these ones should be able to be upgraded to run the latest windows software)

User avatar
Mr Magoo
CNC Guru
CNC Guru
Posts: 301
Joined: Tue 21 Feb , 2006 21:45 pm
Location: Brisbane, Australia

Post by Mr Magoo » Tue 06 Feb , 2007 19:10 pm

This is an NEE version of the Starmill (fitted with an SMCU controller)

It must be connected to a PC to enter and run CNC programs (you can not program the machine from the front panel, only jog it around)

Software and cable diagrams can be found here viewtopic.php?t=196 - use the "Starmill SMCU" software in the zip!

Post Reply