Starmill Rebuild

All info relating to the Denford Starmill CNC milling machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
darent
Posts: 1
Joined: Tue 30 Aug , 2011 14:49 pm
Hardware/Software: Starmill

Starmill Rebuild

Post by darent » Tue 30 Aug , 2011 15:12 pm

I’m rebuilding a 1990 vintage starmill that came my way without any electrics other than the stepper motors and spindle motor. The plan is to fit the mill with new power supply and drivers to run Mach 3.
The stepper motors are MAE HY 200-3424-310-A8 and MAE HY 200-2220-210-A8, looking for the voltage and amp’s for these.
I’m also looking for the pitch of the x, y & z ballscrews.

Simon

User avatar
Denford Admin
Site Admin
Posts: 3642
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Re: Starmill Rebuild

Post by Denford Admin » Tue 30 Aug , 2011 16:45 pm

You sure the answer isn't already on here somewhere ?
eg: viewtopic.php?t=3148

Post Reply