LinuxCNC Conversion, does anyone know the motion contfrol parameters

All info relating to the Denford Router 2600 and Pro CNC routers

Moderators: Martin, Steve, Mr Magoo

Post Reply
JonHodgson
Posts: 2
Joined: Mon 09 May , 2022 14:51 pm

LinuxCNC Conversion, does anyone know the motion contfrol parameters

Post by JonHodgson » Fri 13 May , 2022 19:42 pm

Hi,

We're doing a LinuxCNC Conversion of a 2600 pro using a Mesa board.

The hardware element seems to be done, and we've managed to get LinuxCNC to control it (home, jog the axes, limits correctly set).

The next challenge will be setting up correct speeds and accelerations, are these figures available anywhere rather than doing it by trial and error?

Post Reply