Denford Software & Machines

Posted: **Sun 17 Dec , 2017 1:35 am**

Help please.

Using the original DOS editing program on an Orac how can I tell the tool turret to rotate within a program ?

Marcus

Posted: **Sun 24 Dec , 2017 16:46 pm**

The tool should change if you program an M6 followed by the toolmumber. If the machine thinks it’s a manual tool changer then it will ask you to change tool. If set as an auto toolchanger then it will auto index.

Posted: **Tue 26 Dec , 2017 11:20 am**

Thanks for the info Steve, will pass on the details.

Emgee

Denford Software & Machines

Rotating tool turret command within program.

Rotating tool turret command within program.

Re: Rotating tool turret command within program.

Re: Rotating tool turret command within program.