Novamill control board (can’t connect)

All info relating to the Denford Novamill CNC Milling machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
George2706
Posts: 2
Joined: Fri 04 Feb , 2022 11:50 am
Hardware/Software: Be milling

Novamill control board (can’t connect)

Post by George2706 » Wed 16 Feb , 2022 20:49 pm

Hi all, I have had a novamill for about 3 weeks. Purchased from a friend who acquired and never used. I got it moving manually in jog, so I know it worked. Since I powered it down, never got it moving again! On the top board of the denstep. Capacitor 21 has completely burnt out. I need to know what capacitor to get. Does anyone have a picture of theirs with the required values? The battery has leaked which I’ll remove and Iv cleaned and checked the rs232. Will give it all a thorough test and clean when the boards are out. Hopefully can get it going without moving to full upgrade as bought as working and have all that I need with it. I had it working with the capacitor failing, which is really frustrating. Have been back through every com port configuration before posting. Any advice/help much appreciated.
Attachments
06C76BE5-5B91-4408-88ED-870DD1ECAF2E.jpeg
06C76BE5-5B91-4408-88ED-870DD1ECAF2E.jpeg (723.85 KiB) Viewed 4369 times

Martin
CNC Guru
CNC Guru
Posts: 1897
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: Novamill control board (can’t connect)

Post by Martin » Thu 17 Feb , 2022 10:11 am

Hope this helps
Attachments
Denstep.jpg
Denstep.jpg (15.21 KiB) Viewed 4358 times

George2706
Posts: 2
Joined: Fri 04 Feb , 2022 11:50 am
Hardware/Software: Be milling

Re: Novamill control board (can’t connect)

Post by George2706 » Thu 17 Feb , 2022 18:21 pm

That’s great thank you.

Post Reply