Replacing the spindle drive belt
Posted: Sun 12 Feb , 2017 21:07 pm
Hello, I have had my Novamill about 18 months and during that time the spindle drive belt has started to get noisy. On closer inspection the rubber drive belt is starting to break up. I decided to try to replace it but I am stuck at the point of getting the old belt past the Z ball screw! Would any body be able to advise me what is required to remove the old belt. If it means removing the Z ball screw could you explain how to do this correctly? Has this procedure already been covered in another thread?
Thanks in advance
David
Thanks in advance
David