loose E stop button

All info relating to the Denford Novamill CNC Milling machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
TDIPower
CNC Guru
CNC Guru
Posts: 613
Joined: Tue 29 Apr , 2014 18:38 pm
Hardware/Software: Starturn 5 (sort of running, I will get this done!)
Lathe cam designer V1.11
Quickturn 2D Design
FANUC offline and online programs.
Microrouter Pro NS V5 (microstep)
VR2 and VR5
Boxford VMC260
Techsoft 2d Design tools V1 > V2
ProDesktop
Fusion 360
Deskproto

loose E stop button

Post by TDIPower » Mon 23 May , 2016 20:15 pm

hi folks, just picked up a 2003 Novamill for work, the E stop button is loose. I've not had chance to investigate further but wondered if this was a common problem/how do I tighten it up?

Cheers

Martin
CNC Guru
CNC Guru
Posts: 1906
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: loose E stop button

Post by Martin » Tue 24 May , 2016 13:14 pm

You can get to the nut on the estop button if you remove the lid to the 40mm plastic trunking on the inside of the machine.

TDIPower
CNC Guru
CNC Guru
Posts: 613
Joined: Tue 29 Apr , 2014 18:38 pm
Hardware/Software: Starturn 5 (sort of running, I will get this done!)
Lathe cam designer V1.11
Quickturn 2D Design
FANUC offline and online programs.
Microrouter Pro NS V5 (microstep)
VR2 and VR5
Boxford VMC260
Techsoft 2d Design tools V1 > V2
ProDesktop
Fusion 360
Deskproto

Re: loose E stop button

Post by TDIPower » Tue 24 May , 2016 21:45 pm

I take it that will be accessed from underneath? ill slide it to the end of the bench and have a look.

Fired it up and moved it about a bit today. nice smooth machine, doesn't seem to have the same level of Z travel as the micromill, I did read somewhere on here that someone had put a block in the raise the Z travel up.

Looking forward to running it on projects.

Pete

Martin
CNC Guru
CNC Guru
Posts: 1906
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: loose E stop button

Post by Martin » Tue 24 May , 2016 23:44 pm

You get to it from above. If you look inside the cabinet behind the button you will see the 40mm square white trunking with a lid that snaps on. Just prize it up to gain access.

TDIPower
CNC Guru
CNC Guru
Posts: 613
Joined: Tue 29 Apr , 2014 18:38 pm
Hardware/Software: Starturn 5 (sort of running, I will get this done!)
Lathe cam designer V1.11
Quickturn 2D Design
FANUC offline and online programs.
Microrouter Pro NS V5 (microstep)
VR2 and VR5
Boxford VMC260
Techsoft 2d Design tools V1 > V2
ProDesktop
Fusion 360
Deskproto

Re: loose E stop button

Post by TDIPower » Wed 25 May , 2016 20:52 pm

Cheers, I had a look today and can see how to get at it now.

Pete

Post Reply