Converting a Novamill to Mac3

All info relating to the Denford Novamill CNC Milling machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
Dave123
Posts: 1
Joined: Sun 05 Oct , 2014 11:16 am

Converting a Novamill to Mac3

Post by Dave123 » Sun 23 Nov , 2014 20:57 pm

Hi ,
Have purchased a novamill and wanting to change it to run on Mach3

Looking through the forum I have found a post by Alastair : Bringing my novamill back to life.

I have a few questions on this and wonderd if anyone can help

1 Is there a data sheet which will tell me what each pin of the 96 way connector on the denstep control board does.In the picture that Alastair posted the pulse and limit wires are obvious but I am confussed on what the Brown and Grey/Black does.

Thanks
Dave
Top
Post Reply

Return to “Novamill”