VR Milling losing connection to machine

All info relating to the Denford large format CNC routers

Moderators: Martin, Steve, Mr Magoo

Post Reply
jackmunro
Posts: 1
Joined: Mon 21 Oct , 2013 14:04 pm
Hardware/Software: Denford Vertical Router
VR Milling V5
VCarve Pro
Aspire
Rhino 3D

VR Milling losing connection to machine

Post by jackmunro » Mon 21 Oct , 2013 14:12 pm

Hi,

We have a Denford Vertical Router and are having issues with the connection breaking down between the machine and the laptop. Everything connects fine and the cut begins fine, but at some point it almost always cuts out showing 'Unrecognised error 1227'. It then shows 'Invalid data field length for transaction' if you try to click anywhere.

On the first cut of the day it tends to get a few minutes into the cut before cutting out. If we restart it, it then cuts out before the cut even begins on the next try.

Any ideas what this could be?

Thanks

Jack

Martin
CNC Guru
CNC Guru
Posts: 1897
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: VR Milling losing connection to machine

Post by Martin » Mon 21 Oct , 2013 17:51 pm

A couple of thoughts,

Check all the USB plugs are fully in.

The spindle motor may be causing electrical noise. Check the brushes.

If you have a extraction unit connected it may be causing static due to bad earth. Try running without the extraction on.

Post Reply