Emergency Stop -Old Style to New Style -Microrouter Compact

All info relating to the Denford MicroRouter Compact small routing machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
Benny
CNC Expert
CNC Expert
Posts: 201
Joined: Fri 20 Oct , 2006 15:27 pm
Location: USA

Emergency Stop -Old Style to New Style -Microrouter Compact

Post by Benny » Tue 26 May , 2009 16:07 pm

Customer writes in....

We have an old Microrouter Compact and need to replace the "old style" Emergency Stop Switch with the new style Emergency Stop Switch that has 4 prongs. Please tell us how to switch out from the old style to the new style. Thank you.

User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Post by Denford Admin » Wed 27 May , 2009 9:42 am

Keep the wire pairs together (which are connected to the same block) - if there is more than one pair on the old estop (?)

Then wire them to 11-12 and 21-22 as pairs.
It does not matter which wire of the pairs goes to 11, just as long as the other wire of the matching pair goes to 12
Attachments
NewEstopConnections.jpg
NewEstopConnections.jpg (103.5 KiB) Viewed 7794 times

Post Reply