Denford Software & Machines

Posted: **Tue 13 Jun , 2017 19:50 pm**

microrouter v4ns
running vr milling ver.2
every time the machine reaches a line that begins with "G" the machine stops. as a workaround, someone babysits the machine, hits pause and then play for the machine to move on. it works, but is annoying. i feel like i just have a setting wrong. any suggestions?

Posted: **Tue 13 Jun , 2017 21:14 pm**

What version of VRMilling 2 are you running?

Posted: **Fri 16 Jun , 2017 18:47 pm**

the problem disappeared the last time the machine was restarted! wierd, since we had tried a power cycle...i wish all problems were this easy to solve.

Denford Software & Machines

machine stops at every G code

machine stops at every G code

Re: machine stops at every G code

Re: machine stops at every G code