Denford Software & Machines

Posted: **Fri 30 Nov , 2018 14:52 pm**

I cannot get my New Microturn lathe to Jog. I cannot get the feed to change off of 0%. Any help would be greatly appreciated. [attachment=0]jog problems.

Posted: **Sun 02 Dec , 2018 19:27 pm**

Which tab. Are you on in that picture, it looks like the home rather than job tab.

Denford Software & Machines

Cannot Change feedrate on Denford Lathe

Cannot Change feedrate on Denford Lathe

Re: Cannot Change feedrate on Denford Lathe