Erratic speed control easimill 3

All info relating to the Denford EasiMill and EasiTurn lathes and mills

Moderators: Martin, Steve, Mr Magoo

Post Reply
Jasper
Posts: 1
Joined: Thu 04 Oct , 2018 16:12 pm
Hardware/Software: denford easimill 3
mach3

Erratic speed control easimill 3

Post by Jasper » Thu 04 Oct , 2018 16:43 pm

Help please , i have an easimill 3 with a keb combivert 53 this has the 10k potentiometer connected center pin to ref outer to crf and the other outer to 0v. The problem is if you turn the speed up slowly it will sort of work but the slow down, it slows down at different places when turning the pot, the frequency counter on the combivert always goes up even though it slows down. I have tried a new better potentiometer and new wiring but it is no better,


Any help would be great thank you jasper

Post Reply