Easimill stepper motors?

All info relating to the Denford EasiMill and EasiTurn lathes and mills

Moderators: Martin, Steve, Mr Magoo

Post Reply
plan_b_racing
Posts: 9
Joined: Fri 05 Dec , 2014 13:50 pm
Hardware/Software: Triac PC with ATC, Easiturn3 on Mach3, Easimill, Orac lathe, Zeroturn Lathe

Easimill stepper motors?

Post by plan_b_racing » Tue 05 Sep , 2017 8:46 am

Hi all,
I was wondering if someone could help me. I recently acquired a Denford Easimill 1984 model which is missing all its stepper motors. I was wondering if someone could tell me what frame size the stepper motors are i.e. Nema 34 or 42? Also what holding torque they are? I have been looking on the forum but I cannot find a definitive answer.

I was also wondering if someone could tell me what pulley sizes and tooth number were fitted to the stepper motors.

Hope someone can help.

Many thanks,
Oliver

dgoadby
Posts: 1
Joined: Mon 25 Sep , 2017 19:00 pm
Hardware/Software: modified Easimill.

Re: Easimill stepper motors?

Post by dgoadby » Mon 25 Sep , 2017 19:06 pm

I have one of these machines. I am not using the original controller as it was U/S upon arrival even though mechanics were perfect.

I will try to get the stepper motor sizes and also the pulley toothed belt information for you later this week.

David Goadby

Post Reply