Easiturn 3 - motor drive fault in x

All info relating to the Denford EasiMill and EasiTurn lathes and mills

Moderators: Martin, Steve, Mr Magoo

Post Reply
Olly
Posts: 2
Joined: Thu 06 Mar , 2014 20:20 pm
Hardware/Software: Easiturn 3 - PNC 3

Easiturn 3 - motor drive fault in x

Post by Olly » Fri 07 Mar , 2014 22:16 pm

Hi everyone, I've recently bought a Denford Easiturn 3 from the user on this forum named Ted from Norfolk. I believe he asked some questions about the Limit switches on the machine which I have now replaced.

Here is my problem - when I attempt to Datum the machine I get the message - Motor Drive Fault in X

I have removed the cover from the control system to check the LED's on what i believe are the drivers, and on the left hand driver there is no green LED & only the Red LED in the centre is illuminated. On the right hand driver there is the green led illuminated as well as the red LED in the centre.

Has anyone experienced this fault before? or can anyone point me in the right direction to look for a solution to my problem?

I would extremely grateful if anyone could help.

Thanks
Olly

Post Reply