Easimill bed

All info relating to the Denford EasiMill and EasiTurn lathes and mills

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
radial junkie
Posts: 6
Joined: Sat 26 May , 2012 21:06 pm
Hardware/Software: in the process of a masive orac refit including case etc running on emc2

Easimill bed

Post by radial junkie » Thu 09 Jan , 2014 13:27 pm

Hi ive just found something strange I ordered a bed clamping set and took the manual 5/8 as the T slot size ,when it came I went into the workshop to make some water blocks for my pc's and guess what, the T nuts didn't fit on measuring the T with a set of verniers the T actually is 9/16 could you tell me if this is a standard size for the easimill bed ???

Post Reply