Hi,
I recently purchased a Easimill PNC 2C.
When I put it into joystick mode. (F-1-Accept) it starts travelling to the left, as if the joystick is stuck. When it reaches home, it stops and I have to zero the mill.
The same happens in the Z axis if I set the switch to YZ.
If I center the table, then I can move the Y axis, but it appears to be reversed. ie. If I push up on the joystick the table moves towards me.
Any ideas?
Regards,
Skip
Easimill Joystick Control
Moderators: Martin, Steve, Mr Magoo
-
- CNC Guru
- Posts: 525
- Joined: Tue 14 Nov , 2006 12:12 pm
- Hardware/Software: .....
4 Quatros
3 Oracs
2 Easiturn atc
12 station lathe atc
Mach 3 - Location: Quatroland
Re: Easimill Joystick Control
The movement of the joystick would normally correspond to the tool movement not the table.
Re: Easimill Joystick Control
Thanks for the reply.
i got it working, the potentimeter most have moved so i re-aligned it and all is good.
now that it's working I can see that the movement is relative to the tool.
thanks again
i got it working, the potentimeter most have moved so i re-aligned it and all is good.
now that it's working I can see that the movement is relative to the tool.
thanks again