Easiturn tool offsets

All info relating to the Denford EasiMill and EasiTurn lathes and mills

Moderators: Martin, Steve, Mr Magoo

Post Reply
dscolwill
Posts: 13
Joined: Mon 05 Nov , 2007 21:04 pm
Location: Nottingham

Easiturn tool offsets

Post by dscolwill » Mon 05 Nov , 2007 21:16 pm

Hi
I have an easiturn PNC3 which is connected to a PC via a data link cable however when I save a program no tool offsets are saved. The manual says that if programs are saved to microtape then this information is saved. Is there any way of keeping the tool offsets either in the machine or on the PC.I cannot use the tape as it doesn't work ( I have yet to see one that does ).
Many thanks
David.
Top
Post Reply

Return to “EasiMill / EasiTurn”