silly question

All info relating to the Denford EasiMill and EasiTurn lathes and mills

Moderators: Martin, Steve, Mr Magoo

Post Reply
jpmiller
Posts: 31
Joined: Wed 23 Feb , 2011 9:16 am
Hardware/Software: Denford easyturn pnc2
Converted to mach3

Denford triac servo /G simple/quickcam
Location: Dumbarton scotland

silly question

Post by jpmiller » Thu 03 Nov , 2011 0:12 am


angel-tech
CNC Guru
CNC Guru
Posts: 525
Joined: Tue 14 Nov , 2006 12:12 pm
Hardware/Software: .....
4 Quatros
3 Oracs
2 Easiturn atc
12 station lathe atc
Mach 3
Location: Quatroland

Re: silly question

Post by angel-tech » Thu 03 Nov , 2011 12:18 pm

that looks like a rear toolpost

jpmiller
Posts: 31
Joined: Wed 23 Feb , 2011 9:16 am
Hardware/Software: Denford easyturn pnc2
Converted to mach3

Denford triac servo /G simple/quickcam
Location: Dumbarton scotland

Re: silly question

Post by jpmiller » Thu 03 Nov , 2011 13:59 pm

I sort of thought it might be a rear one,but unsure as to
Where to attach on the rear as there are no mounting
Holes on rear of crosslide lathe was a pnc2.

Thanks scotty

angel-tech
CNC Guru
CNC Guru
Posts: 525
Joined: Tue 14 Nov , 2006 12:12 pm
Hardware/Software: .....
4 Quatros
3 Oracs
2 Easiturn atc
12 station lathe atc
Mach 3
Location: Quatroland

Re: silly question

Post by angel-tech » Thu 03 Nov , 2011 14:15 pm

normally on the backend of the cross slide, take the blue cover off at the back of the cross slide and have a nose.

jpmiller
Posts: 31
Joined: Wed 23 Feb , 2011 9:16 am
Hardware/Software: Denford easyturn pnc2
Converted to mach3

Denford triac servo /G simple/quickcam
Location: Dumbarton scotland

Re: silly question

Post by jpmiller » Thu 03 Nov , 2011 19:52 pm


angel-tech
CNC Guru
CNC Guru
Posts: 525
Joined: Tue 14 Nov , 2006 12:12 pm
Hardware/Software: .....
4 Quatros
3 Oracs
2 Easiturn atc
12 station lathe atc
Mach 3
Location: Quatroland

Re: silly question

Post by angel-tech » Thu 03 Nov , 2011 23:01 pm

there doesn't look like there's a place for it.

Post Reply