Denford Software & Machines

Hi,
The buttons along the bottom ofthe Fanuc screen Do they only work on certain controllers, I have a Fanuc ot-b but the buttons don’t light up or seem to function and also the graphic display of the tool paths can’t get that up either. Thanks

They are Fanuc options, if you have the original parameter list check it against the settings in the control.

you can enable them . Do you have 2 screens to do with your tools to set offsets etc.

I think they were all options but the graphics required a new card fitting.

If you can find the original 900 parameters it would be worth checking.