Fanucl
Posted: Tue 22 Feb , 2022 16:51 pm
Hello all, this may be a goofy question, but on the computer I have hereby my cyclone lathe I have FanucL turning v1.42. I use this quite a bit in figuring things out. The question I have is this, It seems to have an issue with over travel. How would I go about changing this so that I can run programs on it where it's not telling me I have over travel issues. For instance I've got a piece of stock 3 and 1/4" OD, I'm trying to bore it out to a 2.65 ID. In the animation I can only go as big as 2" ID anything over that it says over travel. I don't have the problem with the lathe itself, it's just this animation program. I don't know how to adjust settings in it if that's what I should say. The computer I am using right now is a Dell XP. Thanks Mike