FANUC OT-B MDI mode - how to?
Posted: Tue 20 Mar , 2018 11:18 am
Hi folks,
Well the turret issue continues, I'm going to pull it off over the weekend and begin stripping it down.
In other news I tried to get it to do a tool change via MDI in case the issue was with the manual dial/button.
I have a user guide, FANUC 21i , but that doesn't match my controller or button layout
So this is what I am doing on FANUC OT-B:
I enter MDI mode (press MDI button - it goes red)
I try to type a programme (o0000) then INSERT, or EOB, then INSERT - I get a P/S error
So I try to enter M06 T2 EOB INSERT
Anyway - I keep getting a P/S error
I have a haas cnc mill which I understand but FANUC is confusing as hell, and I can;t find any guides to OT-B anywhere, so if anyone can assist I would be very grateful
It has a rs232 port, so there is the potential for me to send G code to the machine too (I have heard hand coding fanuc OT-B is painful) - but again, I have no idea how to do this on the fanuc, so any assistance would be great
Thanks!
Well the turret issue continues, I'm going to pull it off over the weekend and begin stripping it down.
In other news I tried to get it to do a tool change via MDI in case the issue was with the manual dial/button.
I have a user guide, FANUC 21i , but that doesn't match my controller or button layout
So this is what I am doing on FANUC OT-B:
I enter MDI mode (press MDI button - it goes red)
I try to type a programme (o0000) then INSERT, or EOB, then INSERT - I get a P/S error
So I try to enter M06 T2 EOB INSERT
Anyway - I keep getting a P/S error
I have a haas cnc mill which I understand but FANUC is confusing as hell, and I can;t find any guides to OT-B anywhere, so if anyone can assist I would be very grateful
It has a rs232 port, so there is the potential for me to send G code to the machine too (I have heard hand coding fanuc OT-B is painful) - but again, I have no idea how to do this on the fanuc, so any assistance would be great
Thanks!