Programming software
Moderators: Martin, Steve, Mr Magoo
-
- Posts: 18
- Joined: Fri 06 Jul , 2012 16:36 pm
Programming software
I am new to cnc and input my program via the Fanuc controller key board on my Cyclone. Can anyone recommend any free programming software that would allow me to create the program's on a laptop and upload to the machine?
-
- CNC Guru
- Posts: 613
- Joined: Tue 29 Apr , 2014 18:38 pm
- Hardware/Software: Starturn 5 (sort of running, I will get this done!)
Lathe cam designer V1.11
Quickturn 2D Design
FANUC offline and online programs.
Microrouter Pro NS V5 (microstep)
VR2 and VR5
Boxford VMC260
Techsoft 2d Design tools V1 > V2
ProDesktop
Fusion 360
Deskproto
Re: Programming software
Im not sure on how the cyclone data is read/stored. I have had a quick look on here but would need to know which model you have.
From what I can gather the machine is PC controlled, if this is the case I would have thought you would be able to write the files in windows Notepad, then when you go to save them use 'save as' type the file name followed by a full stop and the file type.
For my Starmill I would type: programname.fnc
fnc is the file type.
where it says 'save as file type' change it from text documents (*.txt) to all files (*.*)
if you can pull a saved program off the cyclone and try to open it in windows, tell windows to open it with notepad that would prove the theory.
Hope that helps
Pete
From what I can gather the machine is PC controlled, if this is the case I would have thought you would be able to write the files in windows Notepad, then when you go to save them use 'save as' type the file name followed by a full stop and the file type.
For my Starmill I would type: programname.fnc
fnc is the file type.
where it says 'save as file type' change it from text documents (*.txt) to all files (*.*)
if you can pull a saved program off the cyclone and try to open it in windows, tell windows to open it with notepad that would prove the theory.
Hope that helps
Pete
-
- Posts: 18
- Joined: Fri 06 Jul , 2012 16:36 pm
Re: Programming software
Machine has a Fanuc 21i controller and I want to communicate through the comm port D connector (RS232)?
-
- CNC Guru
- Posts: 613
- Joined: Tue 29 Apr , 2014 18:38 pm
- Hardware/Software: Starturn 5 (sort of running, I will get this done!)
Lathe cam designer V1.11
Quickturn 2D Design
FANUC offline and online programs.
Microrouter Pro NS V5 (microstep)
VR2 and VR5
Boxford VMC260
Techsoft 2d Design tools V1 > V2
ProDesktop
Fusion 360
Deskproto
Re: Programming software
thats a step outside my knowledge im afraid.
Pete
Pete