Hi again guys!
Having more problems with our Harrison TU150..
Showing an alarm 1021 after homing machine..
Give it time to rest and rehome but then pops up with the alarm again!
Cant use the machine at all!
Any ideas?
Mark
Alarm - 1021 x motor o/heat
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3635
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: Alarm - 1021 x motor o/heat
Probably a broken wire, loose or corroded pin on the cables to the X motor.
(unless the motor really has overheated
)
(unless the motor really has overheated
)Re: Alarm - 1021 x motor o/heat
Machine has been left off overnight so assume overheating is not a problem!
hmmm.. time to get the hammer out!
hmmm.. time to get the hammer out!
Re: Alarm - 1021 x motor o/heat
Hi, did you ever find the problem? My Denford Senior had a VRDY OFF alarm and I played with the motor... Now I have this 1021 alarm. My first thought was brushes / connections??
Thanks,
Paul
Thanks,
Paul
Re: Alarm - 1021 x motor o/heat
Hi Paul.
What motor are fitted?
If it's SEM then it may be a bad connection or a broken wire to the thermal.
If you have the electrical drawings you should be able to locate the drive thermals & check the state in Diagnostics.
What motor are fitted?
If it's SEM then it may be a bad connection or a broken wire to the thermal.
If you have the electrical drawings you should be able to locate the drive thermals & check the state in Diagnostics.
Senior 200 Lathe
Hi all, I'm wondering if anybody knows if you can fit a tailstock to a Denford Senior 200 lathe? Is a large machine & seems a shame not to have one!
Thanks,
Paul
Thanks,
Paul